Painted by a








D16z6 block
Arps
Vitaras
TT rods
Acl bearings
New napa oil and water pump

Few more weeks and this will be in my 94ex coupe

 

nice piggy bank

 

What snail?

 

You like that! It is full too! Might cash that in so I can buy a timing belt.

Also the head is Mexi Chrome

And before JD says I fucked my grounds I am going to sand them down before installing

 

looks good mang

 

Mexi couldn't mask that off? Seems like a pain in the *** to have to sand it.

 

CDM mani
T-3 .42/.48 for now What do you think I will get out of this turbo?

SMALL SET UP

THEN
Sell project bang for the buck and buy BIG BALLER ***** Alll money from this will go in to the coupe

Before this goes in A buddy and I will teach ourselfs to tune on my B7, we went 3rds on the Xeno starter kit

We still need to figure out the data logging

Thanks

 

It will take 5 mins to sand the spots needed

The excitement of having this over a 200K 1.5 will make that sanding seem like nothing

 

Get a h1c and follow the leaders

 

And seal them with dielectric paste. ---- will be mint.