I was inspired by the front page so I welded a junk T3 I had lying around onto my 1981 Honda Passport C-70.... will be doing PVC charge pipes, and then I need to figure out how to do a blow through carb... the exhaust on the bike is cut in half and I welded on a resonator from my old civic, then welded the turbo right to the resonator... I hope I can get these pics to work.

 

AHAHAHa! That isn't going to spool at all! The stock T3 turbine wheel is way too large for your aplication. You'll need an even smaller turbine wheel to get it to spool there. I would say GT17 or RHB3. You could try a T2/T3 (T2 with a really small T2 turbine wheel too. I has a few tiny turbos I'll sell dirt cheap.

 

Yeh this is probably the only time I would say get a smaller turbo , way smaller :1

 

this will not work.

 

I know i need one of those tiny fourwheeler/bike turbos but I dont care, the bike was a freebie and the turbo was too, I guess this project will mostly be for looks. I think it's hilarius to see a turbo hanging off a scooter but then again my family thinks Ima :1 suprisingly the impellar spins with wot...

 

I guess I need nos to spool the turbo like this scooter....

 

family knows best

 

That's pretty cool. I'd rock that, with a helmet and knee/wrist pads of course.