yes of course there is a catch. i have been having head gasket problems since i got the block. Well it turns out the shop that installed the sleeves didnt deck the block so everything isnt flush thus blowing head gaskets. They also drilled out some of the coolant passages. I ran the motor as it is for 3 k miles and it ran good while i had coolant

so this motor is in working order it just NEEDS decked. I am going to throw in the block for FREE if you buy all the internals.

AEBS Sleeved D16y7
CP 9.1 pistons
Eagle Rods
ACL bearings
Polished crank
2 10 an bungs on oil pan
New water pump oil pump
Ill throw in 9 arp head studs if you want yes 9 i snapped 1...

all the parts not including the block is over 1k. I want 725 shipped yes 725 shipped for the complete assembled block (AEBS sleeves installed are 1100). Of course block is sold as is...but it does run and will run even better if the sleeves sat flush...

























I also have a Built head. I think it MAY need resurfaced. Ill throw in the head for FREE if you buy the internals The head has a mild port and polish nothign to rave about ill get more pics of that later. 500 shipped

D16y8 head
Skunk2 Cam Gear
Zex stage 3 105900
Isky Valve Springs and Retainers
Rev Hard Valves

 

was this on a dirt track car ??

 

ha no...coolants plus soot= dirty

 

i'll pay shipping on the block and you can sell the internals separately for your asking price

 

damn man thats a sweet ------- deal if i didnt owe so many people i would def buy this//will you sell the head seperate

 

sooo... this is 725 shipped for the head and engine ready to go and blow some more paper hgs?

 

ummm the head is seperate at 500 shipped

its 725 shipped for the block only and 500 shipped for the head only. together there is over 3k in parts and labor.

 

you put 3,000 dollars into a d16y7 motor? kill yourself

 

thanks for reading jack ***

its a y8 head

and the y7 block with all the same parts of a y8 and sleeved...

 

Hey man, PM on the head! Serious this time!