I have worked my *** off 2 get my lude to where it is today. just wish I had started with some real engine work sooner.
It's a real jdm rhd bb4 with all the goodies 4ws and ----. Rolling on 20'' now. came with a f22b dohc jdm engine. I fucked that one up and found a crashed 94 usdm lude and swapped the engine. Now I have a h22a1 usdm stock internals. Just turbo'd. Running a t3/4 turbo .60 ar, turbonetics evolution wastegate (open loop)and a greddy type s knock off bov.I would love to swap the bov for a 1g dsm bov. I heard there very good and dependable. 2.5 inch downpipe and exhaust. fmu 4 now with stock injectors. Aem tru boost controller. I have the boost @ 5psi right now.Living @ sea level on Aruba. where we don't have many rules on emissions a stuff like that.I'm looking for advice on engine management. and what to do for some extra hp.Lot's of guys here like to use microtec. So far I see one of the best prices on greddy emanage.Since I don't have a built engine yet I don't think I need something expensive. just something that works right with my setup.I'll upgrade my injectors as soon as I have enough $$ saved. Check out my ride on www.cardomain.com/ride/2640096. hope to learn from you guyz and smoke some knuckleheads on the streets and 1/4 mile here...........

 

Post ****, ditch the ------ *** 20s


Then, try again... until then dine on anuscicles ******.

 

tnx 4 the welcome note 2 this forum .I get lots of compliments 4 those 20's. Of course I ain't racing on em. would use some 15's with semi slicks 4 that.
I see you have a baddass h22 set up going.
Maybe you can give me some real advice asswipe!!

 

Hold on I have to beat your mother off of my ****.

 

your gonna want to upgrade fuel suply, lower compresion, ive heard stories of detonation on 6psi with 91 oct

 

SO I guess the dynos off on my 520 WHP pulls at 17 psi huh Good to know....


DIpshit

 

you are a ------- moron

 

the bronze wheels looks **** and i dont care what side you ------- drive on! i want ****! chip your ecu with an eprom setup on 550cc.

 

Grap a hand book and read about the HMT axles and trans breaking,
Look here and search H22A https://www.homemadeturbo.com/forum/...?action=search

 

I have a set of 400+ Hp axles I got on ebay.And a OBX LSD. Not installed yet.Guess I'm gonna run crome pro. Thing is I don't know anybody here in Aruba that uses Crome. There's a dude here running 12's on the 1/4 with microtec on a b series in a 4 door civic.
Other's use Apexi.---- hondata and Aem is 2 expensive