Ethier I'm not looking for the right things or something, cause I can't find any good info/writeups on putting a b16a in a EG.
Links to good write-ups would be sweat, but how do you put it in. I've read different things about the mounts.

If I had the
b16a w/ hydro tranny
intermidiate shaft
axles
rear tranny bracket
driver side L bracket

What would I have to do, besides the wiring( well what pin do you tap for the knock sensor) and pounding the frame for the alternator? axles, mounts, linkage??

 

http://www.enginereplacement.com/htdocs/hondaswap.htm

That was one of the first results on Google. I am sure you can find a ton of ---- on H-T also.

 

I didn't see that. I must have searched something else. b16a on h-t in the 92-00 up got the phone book.

so, if I get a b16a w/ hydro tranny. all i need is the shiftlinkage? the mounts are the same? just put the EG mounts on the b? then just make sure I have the right axles for the tranny.

 

What about doing this ---- on an auto?? is it even worth it?

 

You need the shift linkage, rear tranny bracket from the 99-00 Si, 94 up Teg driver side mount, ac and lower tranny brackets. All these should bolt right in the EG. On a auto you have to do an auto to manual conversion first..more head ache if you don't know what you doing. Good luck.

 

why would he need a 99-00 rear tranny anything if he's putting it in an eg

 

idk...I know I used an 99-00 Si. Had another swap that used a 94 Teg.

 

99-00 Si is EK swap shizzle.

 

over TEN years ago a site Hybrid Honda was born......

this was before HT pussies and the other sites that COPIED the info.

OG Hybrider here.

 

ditto