whats the deal with all the "typhoon" intake manifolds all over ebay? theyre cheap..dont look too bad...anyone on here run on or have numbers on em? such as...http://cgi.ebay.com/ebaymotors/HP-Al...QQcmdZViewItem

 

its a knock off thats why its so cheap and it robilly made like *** cstin defect that sorta thing

 

i know its a knock-off...i want to know if anyone has any experience with them.

 

looks like an aebs replica or whatever you b-series guys use all the time. doesnt look to bad looks liek you could get some usable power from it. if you do get it make sure you check the plenum and runners for excess slag and definatly check the port alignment to a gasket and gasket match if necessary.

 

Thats not a knock off that's an AEBS.
Makes 2hp more than a hype r one

 

I use a AEBS intake mani., they're supposed to be better than a Skunk2 manifold. As far as you put them on the same motor and run them head to head on the dyno. They are cheap though, I got mine from a friend that never used it for $120.

 

Umm it says right in the auction it's "patterned" after the AEBS. Just buy it...worst is that the flange isn't true.

 

They are good.Professional Products makes mainly SBC stuff but its probably a good piece as really there is like $15 in aluninum in a intake manifold for a Honda

 

hhmm..thanks for the input..might just pick one up as cheap as they are..do some port matching and see what happens

 

it is an AEBS manifold. Good stuff.