I was trying to rebuild the block that was in the car, but the cylinders and the pistons were too fucked up, so the new rings i installed didnt seal properly. SO i tore that bitch apart, bought an A6 on ebay for a buck it had been sitting in a garage for about a year, and droped in some pg6 pistons and rods, and the previously installed rings, finally got that bitch running tonight, drove it around the block, you know the typical, speed up, slow down thing, to load up the rings,

My question is, i pretty much took the engine apart, cleaned everything, slapped it back together exactly the way i found it,

Do i have to drive it slowly for the first 500miles, or just drive that bitch to work tommorow (30miles) and consider that bitch broken in?

 

Just drive it normally. But not GhettoD normal. and don't be flippin' off the chocolate faces all the time.

 

its a d series.
drive it.

 

change the Oil after like 20 or 30 miles and Rip on it.

 

since you reused the pistons and rods, just break in the rings doing 4-5 runs from 30-60mph and you should be set. Try to drive it normal for atleast a couple of hundred miles just for assurance. Good luck

 

pull out of your driveway...drive around block...pull back into garage...put on turbo kit....done.

 

well its been 600 miles already, car runs like a champ, no smoke, no leaks.

i was having issues with the stock ecu, it was cutting out after about 5000rpm, so i chipped it to a pm7 program and it cleared it right up.

I want to turbo it but i think 11:1 compression might be too high, or not. hopefully it can handle 9psi

 

wow 11:1

 

of course you can boost it

 

you can boost any thing....just dont expect for it to last long with that compression....