After hours of thinking, I've decided to take apart my old integra seats, more specifically the bracket/sliding system. I wasnt suprised to see that the rails are only in 2 piece... the left and right side. After owning an aftermarket slider/rail/bracket system, I really wished to have the same functionality and ease of the stock OEM ones. So, I went ahead chop, grind, cut, weld, and grind some more on the stock rails. Then I fabricated a mounting bracket for the Recaro seat. I was so stoked of how it came out! Factory slide feel and the seat sits like stock.... which I really wanted. The Sparco seats sat terribly low and the my kitchen drawers worked better than the sliders it came with. The Sparco brackets also didnt fit right. One bolt was always off......

To get a 2 pairs of Recaro sliders and bracket, it would cost me around $250. I didnt spend a dime on this fabrication. The materials are scrap that I already have laying around my garage

 

The paint on the rails are actually black. The flash makes it look like tan-ish. I also welded beads on the corners of every 90 degree bends.