Im running a d16z6 with
je-srp piston 9 to 1
eagle rods
compression check showed 185 psi across all 4
t3 turbine with compressor 60 a/r with 3" inlet.

running 16 psi and 19 degrees timing . is this ok or too much

i tuned it myself with uberdata and a plx m-500 wireless datalogger.
the fuel is fine, just wondering on my timing.
the last colum on my hi cam map is at 19 degrees for 16 psi.

 

depends on some pieces of the turbo setup, but for a base start, id say no.

id say 12psi should sit around 15degrees to start, maybe 13-14 for 16psi.

 

I might even go a hair below that.

Setups change tune around a bit, but 15 deg at 12 psi might start some mild pinging once the engine gets heatsoaked.