my buddy's got a B16 in his CRX and has been wondering what wires do you have to splice from the bseries harness to the DSM injector clips and the resistor box... it is a JDM B16a obd0... i mean does anyone have color to color diagram seeing we have never done this before and pic's would be great too... thanks...

 

ok first off you dont need to be splicing any wires with that set up, the car should already have a factory resistor box, and the injector clips plug directly into dsm injectors, so the only thing you need to do is use a dremel and wobble out the inner diameter of the lower injector seal, because the dsm injector is larger, and it wont fit into the lower seal unless you wobble it out a bit, then grease up the injector when you shove it in, but other than that, its a straight up swap out, no wiring changes needed, but i sure hope you have a chipped ecu with a base map set up for 450's, otherwise your gonna drown the motor in fuel, wash out the oil, and the motor is gonna blow up, god your lucky i felt like being nice......

 

thanks man... i was reading somewhere that wiring had to be changed but thanks for tellng me before we did it....