I remove the PVC hose from the IM while the motor was running to put in some sea foam and it started to rev to 4k +, so turned off the engine and just poured a 1/3 in the IM and a 1/3 in the crankcase. I wait a few minutes and when I go to start it, it turns over and make a horrible sounds and doesn't start. Then when I tryed to start it, the lights on the speedometer just dim and the starter clicks. The starter is good, no prob. untill now. So, I took it in my garage and removed; the starter, plugs, t-belt, oil, and I can't get it to turn over. It'll only go back and forth maybe 3/4 turn. ? ---- I hope the motor isn't fucked.

 

HYDRO....................LOCKED..................o wns you...

 

----!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

 

Ouch

 

Why are you pouring large quantities of liquid into your engine Dribbling a little into the intake while running, okay, but

 

So, what am I looking at here; new bearings, motor??

 

Motor most likely.

 

Your looking at the outside of a motor that wont turn over. Pull the head, pull your oil pan and visually inspect. Than post up pictures of what happens when your fill up your intake manifold with liquid than try and start it.

 

haha damn. Reading instructions pwns j00! Time to tear it apart and check it out....or pull the plugs on a hot day and let the engine sit in the sun to try and dry it out. then see if it starts....prolly not, but worth a shot.

 

if it was hydro locked pulling the plugs would have worked unless you kept trying first and bent a connecting rod.