Can someone please give me a hand doing this? I've never messed with a clutch while it was still in the car. If someone could just stop by for 15 min and point to a few "tricky" things they've learned through experience that would be great. Its a 95integra -

thanks,
Jake

 

loosen wheel lugs, jack front of car up take axles off, unhook trans linkage, take slave cylender off at the tranny but dont disconnect the hydrolic lines to it, drain transmission fluid, disconnect the speed sensor, starter and everything else hooked to the tranny. unbolt tranny from block. take mounts off let the transmission slowly drop with a jack under it or a hoist on the top of the motor. pull transmission off. wash hands good. take off presure plate put new clutch disk in, make sure you dont have it turned around. stick in alignment tool. bolt new presure plate on in the right sequence and tork to spec. reinstall transmission.

 

its pretty easy man

gonna change an auto tranny tonight also
make sure u dont damage any sensors

 

98292? Thats a stanwood area code... where exactly do you live? if you do not mind me asking.

 

Well, now my cars going to get stolen jk, but im by Hagen. (stanwood)

I'll get a 24 pack, I just need some guidance- anyone?

 

LOL... Car stolen in STANWOOD? come on now. I live out in the warm beach area.

 

Oh, your so close dude, 3 minutes away, can u please help! And there are soooo many ------- thiefs in Stanwood , you have no clue.

 

You live in those apartments behing hagen? and Im not the one you want helping you with your clutch... trust me. Im still learning and I would prolly only help you ---- it up.. if anything.

 

Nah, i live in a little development near there. thanks any ways.

 

I'll pick up the car and do the clutch job (not including parts) for 150 out the door