Should the angled oil feed fitting go into the oil source or the turbo?

 

where is the oil line kit from? does it have one angled fitting and one staight fitting?

 

stealthmode...yes, it has one angled and one straight.

 

put the straight on the back and angled on the turbo

did you even look at the picture?

 

thanks

pictures? wut pictures? are u referring to the tunertoys installation instructions? if so, none of my sheets have pictures for the feed line

 

It will work both ways, but you'll be better off turning the block fitting until the outlet points in the general direction that your feedline will go. Put the straight one on the block fitting and route the line. Then the angled one goes into the turbo.

For T25, 14B, RHB5 turbo's the fitting going into the turbo is a straight as well.

 

sounds good thanks

 

actually i was referring to the picture you look at when ordering an oil line kit lol. the pic i posted was right off his site. shows where the angled fitting goes.