will I be able to run uberdata... common sense tells me yeah, but I'm not that familiar on how good the conversion is.... I understand (from the sticky on here) that ubderdata only supports OBD1, and not OBD2.

has anyone done this, convert from OBD2 to OBD1 and ran uberdata... and how did it work out for you? thoughts/ideas welcomed.

thanks,
ray

 

also, i will be running 450 dsm injectors with resitor pack... Im sure that will work out great with uberdata, correct?

 

what obd1 ecu you going to use?

 

All you need to convert to OBD1 is a conversion harness and an OBD1 ECU...

Some OBD2 vehicles have a 3 wire IACV though that doesnt work well at all with Uberdata. Might want to look into that.

 

i have a 00 b18 LS integra... had any experience running that with uberdata?

 

You will be fine using the conversion harness and an OBD1 ecu chipped with Uberdata (more than likely an OBD1 P75). No need to convert the IACV or anything. Just be sure you get the correct OBD conversion harness. They have two different styles. One is for OBD2A which is 96-99 on Integras and OBD2B which is 00-01. You'll want the OBD2B conversion harness.

 

ahh cool! thanks man, appreciate it

 

N.P

 

also with the conversion.... do i still, with a t3/te04 turbo... im gonna run dsm 450's, will need the resistor box with it, and will the clips work with obd-2?

 

Yes you will need to install the resistor box or some 10watt 10 Ohm inline resistors from Radio Shack. Also, I don't beleive the OBD2 Honda clips will work. If you can get the DSM clips that will help alot or you can use OBD1 Honda clips and remove the little notch in the center of the clip so it fits the DSM injectors.