Motor:Golden Eagle sleeved 84.5mm bore ls block with: cp 84.5mm 9.0:1 comp pistons, eagle rods, acl bearings, gs-r crank, arp head studs b20 head gasket, head on the block is a stock gs-r w gs-r manifold (the only problem with the head is when I received it I never got the correct cam caps and one of the caps worn into the cam pretty good so it need to have the cam caps line bored).

Turbo: I have a precision sc-61 turbo, 70 a/r compressor side 3 inch v band on the exhaust. Turbo has 50 miles on it but it need a new compressor wheel ($100) spins awesome, turbo is good for 650 hp says presicion.

other turbo stuff: egt gauge, boost gauge, tial bov, tial 40 mm gate w 11 psi spring, sparco front mount intercooler, 1 extra vortec fmu.

MISC: 2 stock ls heads one is a core one is complete, 1 gs-r intake manifold, 3 b series throttle bodies, 1 stock b16a intake manifold, 2 ls blocks both had spun bearings but would be great for one to have sleeved or built. MSD sci ignition w msd 2 step and blaster HVC coil.

I also have a apex-i vafc 2.

pict of block before it was assembled only 1200 miles right now $1600 without head $1800 with head. This is the full bottom end down to the oil pan. It has new gaskets, gs-r oil pump, gs-r water pump and timing belt. If the block is purched alone it will even come with oil line and fittings for a vtec head.










prices:
turbo $500 OBO
Vafc2 $225 shipped
tial 40mm gate $265 shipped
msd best$170 shipped OBO
pyro gauge $85 obo
tial BOV $150
Sparco i/c $150 plus shipping
fmu $50

 

$500 for shortblock

low ball yes. Christmas made me poor yes.

 

sold it today for 1250

 

hey plz e-mail me at JCGator42@yahoo.com, you have been PMed,
JCC

 

e-mail sent

 

ill take the fmu

 

How much for that turbo timer?

 

turbo timer is sold..I do have the fmu though for the post above you. let me know.

 

I will take the fmu for 50 if you still have it

I am in miramar fl
Let me know thanks.