I aquired me a pm6 for my turbo project and was tring to figure out how to create a basemap or tune. I d/l the ng bin and was tring to figure out how to add the hi/low cam maps to the ng bin file. do i even need to go this far or simply modify daves basemap with the 450cc injectors i want to install?my set up is 1990 teg w t3/t4 5.5psi external w/g,450cc,b16a.

 

you don't NEED hi/low cam maps.

vtec code is not finished quite yet, give it a bit longer.

if you decide to use external vtec activation, just use the ng rom, and enrich where your vtec point would be.

 

yes i am going to get the rpm activated switch for the vtec enguagment.when i richen up where i want to enguage vtec say at 5500 rpms i manually do it right on the tables displayed?so far the only thing i have changed from daves ng bin is checked the box for the 450's i am installing from his original 240's.

 

yes, you change the fuel enrichment right on the table you see in the NG26 fuel map.

I would recommend unchecking the "enable vtec", just to be sure.

if you'd like to, email me the bin or post it on a website and I'll have a look at it.

 

B16MIKE.. i see the PM6 is working out for you

good to hear