I am having no luck searching for this problem.
I cannot get the tranny to seperate from the block. d15
yes all the bolts are out.
any helpful tips? its beginning to frustrate me.

TIA

 

Flywheel cover thing and starter. If it hasnt partially seperated you have a bolt somewhere holding it on.

 

You might be able to get a screw driver or prybar behind the flywheel and pry the tranny off that way. it might take a few tugs before it breaks loose... Or, if your 100% sure there are no more bolts, take a small screwdriver and tap it between the tranny case and the block. That should break it free.

 

Don't use anything hard, use a wood or rubber mallot and give it a few GENTLE wacks to losen the seal. Aluminium is great for weight but not for strength.

 

I'll try the prybar flywheel technique.
I expected it to come apart pretty easily but it had other plans.
thanks again guys

 

rubber mallet that bitch :P

 

it should come apart easy, i bet you misseda bolt, how many bolts did you remove? remember there is a bolt that is kinda hidden on the back side of hte block that holds the block to the tranny.

 

i had a tranny that did that, i used a mallet and a wood block. couple swings and it loosened.

 

just pry that ---- out.

 

are you referring to the bolt right by the axle? I got that beach. Ill pry bar it tomorrow. if that doesnt work im gonna give it a good bash with a mallet. if that doesnt work im gonna push it off my roof.