clocking the turbo???
Thread Starter
0.5 BAR
Joined: Aug 2003
Posts: 140
clocking the turbo???
alright, so i am having trouble getting the oil return to face straight down. The only way i can move the center cartrige is to remove 4 10mm bolts. These bolts won't go in unless the return is about 45 degrees from being straight down.
Any suggestions.
Any suggestions.
3.0 BAR
Joined: May 2003
Posts: 3,365
Re:clocking the turbo???
Originally Posted by Dawson
what if i just left those bolt out?
Are you a dawson's creek fan? "I don't wanna wait till my turbo creep is over..."
3.0 BAR
Joined: Apr 2003
Posts: 11,056
Re:clocking the turbo???
loosen the 13mm bolts (i believe 
) that hold the exhaust housing to the center section about half way, bang the ---- out of it with a hammer, rotate it, tighten back up, and post you're next question.
) that hold the exhaust housing to the center section about half way, bang the ---- out of it with a hammer, rotate it, tighten back up, and post you're next question.
Guest
Posts: n/a
Re:clocking the turbo???
Originally Posted by projekteg
loosen the 13mm bolts (i believe ) that hold the exhaust housing to the center section about half way, bang the ---- out of it with a hammer, rotate it, tighten back up, and post you're next question.
) that hold the exhaust housing to the center section about half way, bang the ---- out of it with a hammer, rotate it, tighten back up, and post you're next question.
