Hi, I am trying to make a T connector to run my oil line. But I can't find the good T for it. what type of thread is it (I am running from a oil pressure sender behind the block). There is no thread that fit properly.

I saw MIP, and alll kinda stuff but nothing work, the size might help to caus I want to run a copper press tubing (plumbing in house)...

Thanks

 

How about specifing car? dont always assume honda on this board please..

Jeff

 

i see stupid people.. everywhere!!

including me.

 

Ok ok ok... it's a b18b engine 1999 in a honda civic 92 !

Thanks

 

mip and fip is what gay home depot carries.

goto a car shop they will have all the brass fittings you will need in NPT

to get the bspt one u can either run a die over the NPT or buy the autometer one. but its 10$

 

what?

 

Just got a Metric Convertion Kit from Autozone, $5.00, the one that goes from bspt to npt, the whole on the side that screws to the block is really small, like a 1/6" Diameter, Is this the correct kit. It says 1/8"bpt to 1/8"npt in the back, with like 5 other things.

 

1/8th BSP is the thread pitch off the back of honda engines.

Jeff

 

man that sentence was a slice of gay.

cant u run a bspt die over the npt fitting to get the right thread?

i know u can cause U JEFF told me u could.

 

Youre all Gay ! No ones answer my question ::