sorry if this has been covered... Ive searched and been reading up, but I havent found much info on this particular issue.


setup: d16a6, hf manifold, dsm t25 turbo

From reading Abaz's comment, the o2 housing/downpipe will not clear the cross member on the crx without cutting it up.

I was wondering how many of you actually did this? and how hard was it? Or, would it be easier buying a flange from BMC and having an exhaust shop make the downpipe tubing?

tia

 

make a DP you're better off that way.

 

you can "Notch" the front cross member if you are comfortable with that, but the DP is going to make a very sharp bend in order to come back up since it will be sitting fairly low. Your better off buying a o2 housing flange from roadraceengineering.com or BMC and take it to a exhaust/fabrication shop to have them make you a down pipe.

Jeff

 

thanks for the replies. I will prob have it fabricated.