What size trim with my planed set-up?

Reply Subscribe

Thread Tools

Search this Thread

Oct 19, 2003 | 06:07 PM

integ3

Thread Starter

0.5 BAR

Joined: Oct 2003

Posts: 52

What size trim with my planed set-up?

I plan on doing a T3 at about 7psi on my '94 integra LS. I'd like to have full boost at 3k rpm's. Since I can only rev to about 6500 rpm's in a LS I don't want to spool any later than 3k rpm's. I was thinking about a .42/.48 T3, or ahould I go with a super 60 which I think is a .42/.60....right?? I'd be useing a tyrus IC with 2.5" pipeing and a stock exhaust and 2.25" downpipe...if any of that makes a difference on spool time.

Oct 19, 2003 | 07:52 PM

greddycrx

Guest

Posts: n/a

Re:What size trim with my planed set-up?

first off, a super 60 is a .63/.60. the .60/.48 is the next one down yet the compressor is bigger than the .42/.48. i'm going to be running the .42/.48 on my D-series crx. if i had an ls i would personally put nothing smaller than a .60/.48 t3! that one should spool up fine on an ls motor. to me, i wouldnt get that either...i like big power even if it does have a bit of lag. I would put a TRUE Super 60 with the a/r's above or a straight T3/T4!! oh and i would use a 2.5" downpipe not a 2.25".