ZC swap in EG help
 

Hi....I recently was looking for a z6 but gave up hope. Instead I found a DOHC ZC at a local junk for 250. It came from the 89 Integras and is cable tranny. My question is I how am I going to get this to work on my EG (93 DX Hatch)? I thought of a couple of things but I wanted you guys to correct me if I am wrong. All I have to do is throw the long block on to my DX tranny and that would bolt up and work? I know the engine is a OBD0. Also which ecu should I use on the motor? I tried searching but really found anything in correspondence to swapping in EG except for OBD0-OBD1 Conversion (Which I haven't gotten the idea yet). Help would be appreciated.

Re: ZC swap in EG help
 

Yes your tranny from your eg will bolt up to the zc motor as for the other questions i have no idea i would try to use my stock wiring harness it should clip up and just run a non vtec ecu with it but like i said im not sure of this never done it but the tranny will bolt up

Re: ZC swap in EG help
 

87-89 integra ECU and engine harness.

Re: ZC swap in EG help
 

the integra D16A1 is a bit different then the ZC balcktop...on one side the motor mounting point is different.
The tranny will bolt on with the 4 most important bolts, that's it...rear dowel won't fit remove it.