Wierd problem, Need alittle help
 

Ok so heres the deal, I was drivign the other night and the car was missing / bogging at 5k rpm's. I ran it up to 5k again and the car stalled out and wouldn't not idle after that. Pulled the plugs and they were covered in gas. So i replaced them, Car was doing to same thing, it would start with my off on the gas but it would be jumping all over the place and would not idle. I let it sit over night and it fired right up in the morning. So i took it for a ride and as soon as it hit 4k rpms it bogged and staled and once again i'm not running. It will start with my foot on the gas but it's really struggleing to run and won't idel. Anyone have any ideas? I don't know what it could be, IT's like once it sits a alittle while it's 100% fine until i hit the higher RPMS or have high load on the the motor, And then it's all screwy again.

Re: Wierd problem, Need alittle help
 

some details about the car might help

Re: Wierd problem, Need alittle help
 

yup, also, any CEL's? how old are all filters/tune up crap?

Re: Wierd problem, Need alittle help
 

No i prefer to guess. Your carb is bad

Re: Wierd problem, Need alittle help
 

Car setup. 1996 LX 4dr
Bully built B18b1 block & head.
RC 550 injectors.
Walbro 255 fuel pump
B&M FPR
All pumps, belts and filters are new,
400 mileson the motor sence start up,
Running crome with no CEL's tuned by chris (xenocron)
18g turbo, ect ect.
Like i said the problem just started, It's so wierd. The car is fine until i get on it just alitte, don't eve have to boost it for the problem to acure. and then once the problem comes up the car is fucked for like 5 hours then it's ok again. I just can't figure it out.

Re: Wierd problem, Need alittle help
 

Any thoughts? What should i start checking?

Re: Wierd problem, Need alittle help
 

from what it sounds like i would go to the basics, check your sensors, thats probly where the base of the problem is at, i'm no honda tec, but my best guess would be to check all of the sensors, ex like oxegen,tps, check fuel press, odd, but may have fuel injector problems, just because its new, dosent mean its right

Re: Wierd problem, Need alittle help
 

Well last night i pulled off the dizzy cap to check the cap and rotor and i found the retaining screw from the rotor sitting on the top sensor pickup inside the dizzy, Looked inside the cap and there was a ton of carbon dust. So i'm hoping it's jus the cap and rotor that got fucked and not the actual dizzy.

Re: Wierd problem, Need alittle help
 

so i'm going to get a cap and rotor in an hour and put it in, Does anyone think this is going to solve my problem?

Re: Wierd problem, Need alittle help
 

you'll know in an hour if it works :P, there's no harm in doing a tune up like replacing dizzy components