stock d16z6 w/ y8 IM
ebay t3 super 60 @ 10psi
dsm 450cc
crome pro
~11.3 afr plx m300
running 93 pump gas.







#4



#3



#2



#1


__________________________________________________ __________________________________________________ __________

#4



#3





#2



#1










obvious reason, it blew the ---- up. #2, #3 and #4 rod broke to ----, w/ #3 being the worst.



ideas to why ?

 

Nothing wrong. Put oil back in it.

Why dont you tell us the stupid ---- you did? WTF kind of plugs are those anyways? Im assuming timing, hot plugs, and shitty tune. Badda bang.

 

post the timing map

 

Y8 intake.........#4 was lean

 

Those are bosch platinums plugs.To hot for turbo.Looks like you baked the ---- out of the block and head.Number 4 exhaust valve's looks bent.

 

Pistons go bangy bangy.

 

didnt do anything. just got it tuned through out the rpm range and went to do a full pass. in 4th gear around 7k at ~120mph it kind of studered for just like a sec and then it started going and thats when it went. i have no idea.
aft's were in low to mid 11's under boost at all times.

plugs are bosh super 6

 

Last time I saw a dyno sheet on a 60 trim t3/b16 it made almost 280hp@11psi. Taken into the account of less cfm flow for a z6, and I'd still say you were making above 200hp on a stock block. What happened to you was nothin more than stupidity and failure to read/compute air flow maps. :P

 

nah, it cant be that simple. lol but the car was pulling pretty good