what causes all 4 injector O rings to fail at once?
 

see title

Re: what causes all 4 injector O rings to fail at once?
 

thread overload?

Re: what causes all 4 injector O rings to fail at once?
 

i've been gone a while, buk err jay have you boosted anything with wheels yet?

Re: what causes all 4 injector O rings to fail at once?
 

whats a thread overload?

well i was rolling your mom arround on a cart if that counts ;D

i just got the gsr crx on the road and im dealing with bullshit issues.. so i cant boost a car plauged with bullshit issues :(

Re: what causes all 4 injector O rings to fail at once?
 

something contaminated and rotted the o-rings... ???
I don't know if gasoline can do that depending on how it sits. Maybe its just old age.

Re: what causes all 4 injector O rings to fail at once?
 

im just watching this bitch get hit by that ------^

Re: what causes all 4 injector O rings to fail at once?
 

You sure you have the correct orings for the manifold?

Re: what causes all 4 injector O rings to fail at once?
 

you cause all 4 orings to fail at once.

/thread

Re: what causes all 4 injector O rings to fail at once?
 

well its o rings into the fuel rail and yeah they are the same o rings ive been running since i finished the swap..

atleast 3k miles on it with no issues untill this happend the otherday...

i filled up from 3 different gas stations the day it started.. 5 bucks worth of gas.. then 7 bucks worth.. then 6 bucks worth.. so id have no way of knowing which gas station :(

i always run the highest premium they have.. should i stop doing that and run 87?????


STFU FAGGOT.

Re: what causes all 4 injector O rings to fail at once?
 

ethanol dried your ---- out, but i doubt gas would do it at 10% blend

Re: what causes all 4 injector O rings to fail at once?
 

Clogged return or failed regulator causing an increase in fuel pressure? Or are the o-rings actually damaged?

Re: what causes all 4 injector O rings to fail at once?
 

After I got my buddies old accord running after sitting for 4 yrs the first thing that bitch wanted to do is spray gasoline all over the engine bay out of all 4 cylinders. Just replace the O'rings and see how it goes. If it happens again then you know you've got a problem. Your weird not stupid Buk. You'll figure it out.

Re: what causes all 4 injector O rings to fail at once?
 

Have you pulled them out yet to see what they look like?

Were they installed using any kind of petrolum based lubricant?

Re: what causes all 4 injector O rings to fail at once?
 

This is what I told him. I'm assuming they dry rotted from sitting without any fuel in the lines for so long.

Re: what causes all 4 injector O rings to fail at once?
 

well they were installed before i got the engine and ive put alot of miles on it..

they all look like they blew out of one side..

if they were dry rotted wouldnt they have all failed as soon as i got the damn car running and idt they would have failed all together?

---- if i know

Re: what causes all 4 injector O rings to fail at once?
 

Just change em out. Its like $20 worth of parts for injector seal kit.

I always use water based lubricants when installing the seals. No oil to worry about damaging them. KY works good. :6

Re: what causes all 4 injector O rings to fail at once?
 

Pull them out and see what they look like

Re: what causes all 4 injector O rings to fail at once?
 

as in the oring physically extruded out of the pocket? Mine did that when I tried to stuff the wrong oring in and didn't get it in quite right. The rail bolted down until it was tight, but in actuality it wasn't down all the way onto the little spacers. So that left some room for the oring to squeeze out.

Was your rail bolted down all the way?