HomemadeTurbo - DIY Turbo Forum

HomemadeTurbo - DIY Turbo Forum (https://www.homemadeturbo.com/)
-   Hybrid/Tech (https://www.homemadeturbo.com/hybrid-tech-8/)
-   -   what can cause tachs to read wrong? (https://www.homemadeturbo.com/hybrid-tech-8/what-can-cause-tachs-read-wrong-5098/)

Honda16hb 05-17-2003 04:03 PM

what can cause tachs to read wrong?
 
I installed a Sunpro 85mm tach yesterday. I'm afraid it might be reading too low, or that I drive like a -----. my idle is at 700, and the highest I've ever taken my engine was 5000 (looking at the speedo, then at both speedo and tach). I tapped the blue tach wire just behind where it clips into the gauge, I plugged the positive wire into a slot labeled 1 on my fuse box thing, the ground is to a grounding bolt under the dash on the driver's side up against the outside wall. the light souce is the dimer switch for the gauges. could any of this cause a wrong reading?

Honda16hb 05-18-2003 01:33 PM

Re:what can cause tachs to read wrong?
 
I think it's reading just dandy, I revved to about 6.3 and my engine didn't explode.

91rexBUG 05-19-2003 03:42 PM

Re:what can cause tachs to read wrong?
 
you hooked it up right so it shouldnt read wrong..the only way it would read wrong is if the calibration of the tach

lewis

88crxSi 05-20-2003 08:31 AM

Re:what can cause tachs to read wrong?
 
not if the idle is at 700.. its working fine.. just press your pedal down farther ;)

leed 05-20-2003 03:12 PM

Re:what can cause tachs to read wrong?
 
Ground problem, poor connections.
Thats what can make a stock one start to jump around. (among other things)


Honda16hb 05-20-2003 09:25 PM

Re:what can cause tachs to read wrong?
 
ya, when I had the ground loosely connected it jumped around, but I'm pretty sure it's reading accurately because I've gone over 6000 and no rev limiter or engine exploding.

donalson 05-21-2003 02:16 AM

Re:what can cause tachs to read wrong?
 
take the car for a spin... read of the MPH and the RPM... also remember what gear you are in.

go home and yank out the big calculator... figure what RPM the motor should be turning at the given MPH... rember you gota figure what the gearing is from both the gear you are in and the final drive :)

mark

88crxSi 05-21-2003 08:54 AM

Re:what can cause tachs to read wrong?
 
nah, forget that..

3000rpm in 5th gear at 60mph, on a d16a6 w/ Si Tranny.

but if u dont have that engine/tranny.. what do u have??

Honda16hb 05-21-2003 07:28 PM

Re:what can cause tachs to read wrong?
 
dx tranny, I hit about 2500 at 60

my second gear seems to match my mph: at 25 its 2500, at 40 its 4500 at 60 its 6000.


All times are GMT -5. The time now is 02:49 AM.


© 2024 MH Sub I, LLC dba Internet Brands