HomemadeTurbo - DIY Turbo Forum
Page 2 of 2
1
2
Show 40 post(s) from this thread on one page

HomemadeTurbo - DIY Turbo Forum (https://www.homemadeturbo.com/)
-   Hybrid/Tech (https://www.homemadeturbo.com/hybrid-tech-8/)
-   -   Turning a honda crankshaft = bad??? (https://www.homemadeturbo.com/hybrid-tech-8/turning-honda-crankshaft-%3D-bad-48864/)

Mindless 10-27-2005 03:43 PM
Re: Turning a honda crankshaft = bad???
 
Originally Posted by gsrcrxsi
are they the oversized ACL's?
Jesus christ.....yes they are oversize. :1

Ravage70 10-27-2005 04:43 PM
Re: Turning a honda crankshaft = bad???
 
dont replace what doesnt need replacing

if its working fine why ---- with it again

Slo_crx1 10-27-2005 06:35 PM
Re: Turning a honda crankshaft = bad???
 
Originally Posted by absolutezroo
yes there is a nitride (is that the right word?) coating on the oem honda crank
He's right...honda cranks are nitrided. Usually turning them down removes this and makes the crank weaker. Worse case scenario, don't beat it, and don't rev the piss out of it.

Semnos 10-30-2005 12:39 PM
Re: Turning a honda crankshaft = bad???
 
yup nitrided...they harden/treat the surface of the journals and then micro polish it.

DeleriouS 10-31-2005 03:36 PM
Re: Turning a honda crankshaft = bad???
 
how much hp do you guys think a stock b18b crack could take?

HMT-Admin 10-31-2005 03:40 PM
Re: Turning a honda crankshaft = bad???
 
Originally Posted by DeleriouS
how much hp do you guys think a stock b18b crack could take?
I've seen stock b18a/b cranks hold over 650whp. I think it would be one of the last things I'd be worrying about in your setup. It's pretty rare to see a honda crank break.

themadhatter 10-31-2005 10:16 PM
Re: Turning a honda crankshaft = bad???
 
if your worried about it just say ---- it and get a new crank d16 cranks arn't hard to find and any d16 crank should fit in your zc


All times are GMT -5. The time now is 12:19 PM.
Page 2 of 2
1
2
Show 40 post(s) from this thread on one page


© 2024 MH Sub I, LLC dba Internet Brands