Paperchase013

supp guys, i set a new record today, boosted my motor for the second time (after blowing the last one and selling the kit) . the car blew up on the first run, timing belt busted and I bent a valve. STUPID ME.


anyways, a buddy of mine gave me a turbo head gasket, its aabout 1cm thick. i dont know who made it, and im trying to figure out how much lower my CR will be. its a stock D16z6 and i belive the CR is 9.2, any1 know how much lower CR im looking at?

thanks in advance.

turboDXcoupe

Yeahhhhh!!!!!!!!!!!

Paperchase013

Donald125

1cm headgasket in Z6 yeild 5.5:1 compression.
hope u mean 1mm

Paperchase013

sorry, its more like 1/8th inch. how much would a 1mm gasket yeild??

Donald125

9.0 :1 ?
here u go. d series C/R caculator
http://www.knology.net/~jediklc/D.htm

y49crxsi

well, a 1/8 inch thick headgasket would be 7.7 : 1 on a d16z6. to low. Are you sure its 1/8" thick. MEASURE IT. youll need a better tool than a ruler thought to be exact.

B16Drag

DAMN where hell are those calculator for the B series!!!

Anyone know where to get some gaskets to lower the B16's?

Dr.Boost

Here you go buddy.
http://www.c-speedracing.com/howto/c...c/compcalc.php
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote

B16Drag

BOOST You da man! I just hope u were the lucky guy in your avatar! haha!

Everytime open up this messageboard I always gotta watch myself because of your sickening yet very "pleasurable" avatar! hahah