How would you go about converting it into a spool; any good write up's? Thanks for the info

 

by overlaying the 4 clutch plates, about .255-.260" thick total, and having it laser cut out of plate steel

 

So you want to have a single 6.5mm think plate to make it full look All the time. Hum..... Maybe Wier can make the plate......

 

Likely Machintek will be making the parts.....

http://www.machintek.com/

I race RC cars with the owner, might end up working/LEARNING part time for him. He doesn't like to do small runs or one-offs, not profitible. But if I'm willing to learn a little that will benefit BOTH of us, he might have a spot for me.

And I might have a place to make better alum. D series shifter forks. Instead of being from weak cast, cut from a billet, alot stronger. I mentioned "I'm bored" and "I need a challenge" that interest me.

"You'd be PERFECT!"

Maybe a brighter future ahead!

 

d series shift forks would be kick ***. i would def buy a set (for a resonable price)

 

You and a ton of other people would to!!