ok so i put my new motor in today, the only thing i changed on the setup was a new clutch from LSD mike. tranny is a gsr with type lsd, has 35k on it and has never had any problems. so i get the car started and go to pull it out and the downpipe hits the lift. so i pull it forward put two blocks behind the wheels get back in put it in reverse let the clutch out and NOTHING> !!! car doesnt even move. put it in first same thing. what the ---- good this be? like i said the only thing i changed was the cltuch, i was using on the built gsr a ACT 6puck with xtreme pressure plate. im gonna have my boss look at it tomorrow and see what he thinks cause im stumped, i bled and re bled the clutch. what are the chances of it being the clutch vs the tranny?

 

maybe throwout bearing

 

Jordan how stiff is the throw out lever coming out of the tranny?

 

axle wasn't fully seated and popped out

 

Listen to Bone. One thing to remember about the clutch is that even if there is no TO bearing or fork in there, the clutch will still be engaged. If there is no fluid in the lines or it needs to be bleed, it means that the clutch will be engaged.