Timing Belt Problems
I have finally got my timing belt on, and the TDC all lined up. Starts right up, but I have to turn it off immediately because the belt is sliding off the cam gears and water pump. Any ideas what causes this and how to stop it?
Adam |
Re:Timing Belt Problems
the tensioner pully might be bad..or did you tighting your belt good enough?also did you pull the crank pully off?if you don't put the spacer back on your belt will hang somewhat off the cam gear..or could be a stretched belt..
|
Re:Timing Belt Problems
The belt seems to be nice and tight. I did tighten the tensioner bolt. Perhaps maybe too much? I just found that damn peice you're talking about on the crank pulley, that isn't on. I spaced it.
Also I should mention the plastic cover for the side is not on yet. I was just trying to make sure I got everything right before putting it back on. The belt is brand new, I wouldn't imagine the belt would be stretched out. I'm replacing the water pump, so I figured I'd do the timing belt since I'm there. Also this is on a DOHC ZC. Thanks for the quick response man. |
Re:Timing Belt Problems
yeah but i have bought belts new and some how where stretched.i bet its just the spacer.. good luck
|
Re:Timing Belt Problems
make sure the belt retainer is on.
theres one before and after u put the belt on the pully. |
All times are GMT -5. The time now is 03:27 PM. |
© 2024 MH Sub I, LLC dba Internet Brands