Spun a rod bearing on my f22 turbo...
 

My engine is a f22a6...

What should i do? Change the block only... Rebuild?
If i rebuild... how hard it is? Never done that before...

Re: Spun a rod bearing on my f22 turbo...
 

crank is done for



find another block

Re: Spun a rod bearing on my f22 turbo...
 

Eh, if the mains haven't fucked the block, then you can just replace the crank and whichever rod you nuked.

Your spun rod bearing is most likely from detonation or the fact that F22 is unbalanced swill crankshaft. Chekc upper bearing halves - if they have more wear than the rest of the bearing then it is detonation.

I think H23A1 block with H22 crank rods pistons is the cheapest way to go FTW

Re: Spun a rod bearing on my f22 turbo...
 

I didnt mean the block was junk just it would proably be easier just to replace the shortblock has f22 blocks are pretty cheap



crank is done for though

Re: Spun a rod bearing on my f22 turbo...
 

Well hell yeah then jus find a shortblock and throw it in then. last year I let my sister borrow my old accord for over a month it leaked some oil. lonf story short she ran it dry and it threw a rod a few days after I got it.I had put oil in it but at that point the damage was done. I found a shortblock at a garage in cincinnati for 200 bucks. they said it had only 100,000 on it they pulled it out of a well maintained wrecked accord. I tend to agree with that because when I inspected the motor the timing belts were brand new and it had the balance shaft seal holder installed on it that was a recall item from honda because those seals would just randomly pop of from time to time.

just find another shortblock man their cheap.

Re: Spun a rod bearing on my f22 turbo...
 

get another shortblock or at least another crank. Might as well get all the spare parts with it. Im going through a similar problem with my accord, my number 3 main is destroyed, and so is the block

Re: Spun a rod bearing on my f22 turbo...
 

get a jdm f22b dohc. get some forged pistons and rods and boost away. that setup can support over 400whp safely. ----, a stock f22b dohc can support over 320whp stock.

Re: Spun a rod bearing on my f22 turbo...
 

Yeah jdm f22b's are cool. their chap to as far as a whole motor goes I found one a while back for like 800 shipped to my front door.

Re: Spun a rod bearing on my f22 turbo...
 

im about to buy one for 750shipped :D

Re: Spun a rod bearing on my f22 turbo...
 

well that suck... story is the engine overheated... result rod bearing bye bye... but headgasket is fine...

did a compression test... engine was cold and i got 150-155-155-155 for a 8.8:1 comp ratio. Its raining now but once the sun shows up, i will remove the oilpan and check all the bearing.