simplified b16a in EG how to???
#1
simplified b16a in EG how to???
Ethier I'm not looking for the right things or something, cause I can't find any good info/writeups on putting a b16a in a EG.
Links to good write-ups would be sweat, but how do you put it in. I've read different things about the mounts.
If I had the
b16a w/ hydro tranny
intermidiate shaft
axles
rear tranny bracket
driver side L bracket
What would I have to do, besides the wiring( well what pin do you tap for the knock sensor) and pounding the frame for the alternator? axles, mounts, linkage??
Links to good write-ups would be sweat, but how do you put it in. I've read different things about the mounts.
If I had the
b16a w/ hydro tranny
intermidiate shaft
axles
rear tranny bracket
driver side L bracket
What would I have to do, besides the wiring( well what pin do you tap for the knock sensor) and pounding the frame for the alternator? axles, mounts, linkage??
#2
Re: simplified b16a in EG how to???
http://www.enginereplacement.com/htdocs/hondaswap.htm
That was one of the first results on Google. I am sure you can find a ton of ---- on H-T also.
That was one of the first results on Google. I am sure you can find a ton of ---- on H-T also.
#3
Re: simplified b16a in EG how to???
I didn't see that. I must have searched something else. b16a on h-t in the 92-00 up got the phone book.
so, if I get a b16a w/ hydro tranny. all i need is the shiftlinkage? the mounts are the same? just put the EG mounts on the b? then just make sure I have the right axles for the tranny.
so, if I get a b16a w/ hydro tranny. all i need is the shiftlinkage? the mounts are the same? just put the EG mounts on the b? then just make sure I have the right axles for the tranny.
#5
Re: simplified b16a in EG how to???
You need the shift linkage, rear tranny bracket from the 99-00 Si, 94 up Teg driver side mount, ac and lower tranny brackets. All these should bolt right in the EG. On a auto you have to do an auto to manual conversion first..more head ache if you don't know what you doing. Good luck.
#6
Re: simplified b16a in EG how to???
Originally Posted by zebvaj
You need the shift linkage, rear tranny bracket from the 99-00 Si, 94 up Teg driver side mount, ac and lower tranny brackets. All these should bolt right in the EG. On a auto you have to do an auto to manual conversion first..more head ache if you don't know what you doing. Good luck.
Thread
Thread Starter
Forum
Replies
Last Post
Guy-Fast
Turbo Parts For Sale
0
08-11-2005 06:09 AM