Rods for D16Z6 10psi
 

10psi on stock Z6...is the rod going to hold up?...
how much would shot peen helps?...
and anyone knows if there`s any aftermarket rod will fit stock pistons?....

Re:Rods for D16Z6 10psi
 

10 psi should be fine. Thats what I am running on my B7.
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote

Re:Rods for D16Z6 10psi
 

All aftermarket z6 rods should fit stock pistons, but why? I'd say get a set of eagle rods (I've seen them as cheap as $275 a set) and a set of SRP pistons (Also around $250-$275 a set), and do them both. You'll be much happier in the long run. I got Crower rods (the good ones) and Arias low compression pistons for $400 new. Right place at the right time.

Re:Rods for D16Z6 10psi
 

saw some eagle rod going for 350
but AFAIK most of the aftermarket rod does not accept press-type pin..
dude 500 for both rod and piston would be good deal but where?...
$wise....

Re:Rods for D16Z6 10psi
 

long as you dont knock to much the stock rods can take the pressure.

Re:Rods for D16Z6 10psi
 

You could use stock integra Ls rods. They will handle 12-14
pounds and you can get them for cheap.

Re:Rods for D16Z6 10psi
 

i have a LS block in my house but...
with the Ls rod u will have to shave the big end...
adn u will need some custom bushing for it

or r u talking about the 1G integra rod that bolts in..
hard to find tho....u know hwo all the junky yard says 'um..86 to 89 r all the same"