quick vitara question + porn now NSFW
#1
quick vitara question + **** now NSFW
about to order my parts want to confirm a few things
0.006 piston to wall clearance for safe 400 hp ? ill be going for 300 at first but just in case
now with that clearance am i ok to run standard bore rings or should i get over sized and shave the gap bigger?
wondering wich rods off of tunner toys you guys recommend, figure they can all handle my power goals and $50-100 is not a big deal
rev cut will be 7500 rpm
also it dosent say if the wrist pins are pressed in to the rods or if they float
thx in advance, ill post **** and major riper vids
0.006 piston to wall clearance for safe 400 hp ? ill be going for 300 at first but just in case
now with that clearance am i ok to run standard bore rings or should i get over sized and shave the gap bigger?
wondering wich rods off of tunner toys you guys recommend, figure they can all handle my power goals and $50-100 is not a big deal
rev cut will be 7500 rpm
also it dosent say if the wrist pins are pressed in to the rods or if they float
thx in advance, ill post **** and major riper vids
#2
Re: quick vitara question
I don't see no **** you ricer. And the pins are floating if the rods have a silicone bronze bushing in the small end of the rod and you use the clips to hold them into the piston, but I've seen other rods that are press-in. As far as I know, I haven't seen TunerToys sell the press-in types, only the floating types which are much easier to put together.
#4
Re: quick vitara question
thats what i thought but wasn't sure (rods + wrist pins)
hook me up with a link for the piston ring gaps, plz
i was thinking of getting eagle rods since they have apr2000 bolts, but couldn't find any info on them worth it?
and heres something for now
hook me up with a link for the piston ring gaps, plz
i was thinking of getting eagle rods since they have apr2000 bolts, but couldn't find any info on them worth it?
and heres something for now
Thread
Thread Starter
Forum
Replies
Last Post
buk9tp
General Discussion
37
02-12-2008 12:49 AM