PR3 Pistons in a B18A Block
I'm planning on building a LS/VTEC for All Motor Duty. This build wont be anytime soon, but My buddy is building his b16 and is willing to give me the pistons if I can use them.
So my Question is will PR3 Pistons in a B18A Block with a B16A Head work? Or will I have some Valve Clearance or any problems like this. This will be my first N/A B-Series Motor so forgive my ignorance. |
Re: PR3 Pistons in a B18A Block
No you will be fine. I did this set up for soemone awhile back very nice cheap build. Jeff had this set up also in his tt ls/vtec build
|
Re: PR3 Pistons in a B18A Block
Cool. What does it give CR Wise? I calculated about 11.8 or some where around there. I hope when this motor is built (Spring 2007, but I'm going to be broke for a while so I'm collecting now) with ITB, Mybe some Cams and 11.5 to 12:1 CR I'll get 200whp on a good tune.
|
Re: PR3 Pistons in a B18A Block
ya in that range depending on if you mill the head and what headgasket you use
|
Re: PR3 Pistons in a B18A Block
doing one right now for my customer.
B18a block b16 pr3 pistons b18a rods arp rod bolts b16a2 head 2 layer head gasket. cr is roughly 11.7 with a stock head gasket you will yield around 11.5. |
All times are GMT -5. The time now is 09:27 AM. |
© 2024 MH Sub I, LLC dba Internet Brands