Wondering what I need to make this work besides mounts and ---- I mean how can I get it to be OBD1 compatible is it just the dizzy and ecu?

 

and...
obd1 engine harness
obd1 tb
vss
shift linkage
injectors

im a noob I dont know what else

 

I have the dizzy for sale. PM me if you need it.

 

Ur better off getting an obd1 intake manifold (complete), waterneck from obd1 with the temp sensor in it, integra upper radiator hose, You can use The axles/intermediate shaft (if its from a 90+ integra), you just have to change out the O ring on the drivers side of the hydro transmission and the axle (half shaft) will fit. You need a integra throttle cable too ( or a custom bracket for your eg throttle cable). theres a few more things i think but i cant think of em right now. Its a lot of stuff, i just finished converting my obd0 B18A1 into my OBD1 eg.

 

Pretty much all of the sensors form obd0 will work with obd1. Dizzy needs to be changed, and obd1 runs a 4-wire o2 sensor as well. I have a mix and match of obd1 and obd0 sensors on my LS, and i've run it both as obd0 and obd1 and they all check out fine. Just make sure if you're still running obd0 injectors, the resistor box is a must, even on obd1.