davcivic

I just finished doing the DPFI to MPFI swap but I'm not sure I routed all the vaccum and water lines correctly. The car starts fine, but I want to check that everything is in the right place before I drive it. I've been looking all over the net for pictures of cars to see where the lines go to. Do any of you guys have some that could post or maybe e-mail me.
Thanks so much in advance.
davcivic@yahoo.com
Davic

davcivic

Don't worry found what I needed on hybrid-honda's website. They have a complete Shop manual in PDF format, I downloaded it and found both water and vacuum diagrams.

Honda16hb

do you have a link to it? did you push the pins out of the plug or just cut and splice them?

davcivic

I tried to take out the pins but could not, so I cut, soldered and then used heat shrink on all the connections to make them as durable as possible, then I used electrical tape to tie them all down, it was really easy. I'll look for the link on how to do the swap and the shop manual.
I'll be right back

davcivic

The service manual is here:

http://tech.hybridgarage.com/tech/ma...vicemanual.pdf

Then this is a Vtec suplement to it:

http://tech.hybridgarage.com/tech/ma...supplement.pdf

I want to print them out but it's like 1000 pages, I did a right click on them and saved them to my hardisk for future reference.

If the links don't work go here and look for 4gen swap info

http://tech.hybridgarage.com/tech/index.html
And this is a very good write up on how to do the swap, I follow the steps and had no problems.

http://pub161.ezboard.com/fbseriesal...picID=28.topic
Hope this helps