need help setting tps sensor!!!
#1
need help setting tps sensor!!!
I just installed a skunk2 im and tb on my 99ex with a d16y8. i forgot to check the stock position on my tps sensor before i took it off the stock tb. does anyone know what the stock settings for the y8 are? I have already tried .45 at throttle closed. any help is appreciated need to get car running right so i can stop bumming rides.
#2
Re: need help setting tps sensor!!!
0.5 volts when the throttle is closed, and 4.5 volts at WOT.
Use a volt meter and tap into the TPS signal and ground wires. Gradually open the throttle and watch the TPS voltage reading. Adjust TPS if needed until the desired voltage is reached.
Use a volt meter and tap into the TPS signal and ground wires. Gradually open the throttle and watch the TPS voltage reading. Adjust TPS if needed until the desired voltage is reached.
#5
Re: need help setting tps sensor!!!
Originally Posted by jdubs111
the reason why i ask is i tried .5v also and it still idles like ----.
FYI...the last time I did mine, I did it without a volt meter and everything is OK.
#7
Re: need help setting tps sensor!!!
Originally Posted by jdubs111
i can get it to either surge or idle at 3k. i have tinkered with it for two days now. is there a way to reset the little bastard.
#8
Re: need help setting tps sensor!!!
this maybe my ---- up. disconnect the iac valve from the manifold or just unplug it. because i have the idle screw almost all the way in but i did not know about diconnecting ithe iacv.