NAME THIS NUT SIZE!! Lowermost LCA Nut- Lost Mine
 

I need to know the size of the nut that attaches under the bottom of the front lower control arms, I wanna hit the store in 20 min and get this back assembled but I dont know what size this is and Ive lost both so I cant compare and everything else is already assembled
Thanks

someone elses pic

http://www.imagestation.com/picture/...5.jpg.orig.jpg

Re: NAME THIS NUT SIZE!! Lowermost LCA Nut- Lost Mine
 

http://www.hondaautomotiveparts.com/...tcgry5=KNUCKLE

#19. Says, 12mm. Id guess 12x1.25

Re: NAME THIS NUT SIZE!! Lowermost LCA Nut- Lost Mine
 

Must be it eh, thanks leed

Re: NAME THIS NUT SIZE!! Lowermost LCA Nut- Lost Mine
 

ya its a 12mm and you need a pickle fork to jam in between the ball joint and hammer it lose.if you are replacing it make sure you get a castle nut so you can throw a cotter pin in there. kthx bye

Re: NAME THIS NUT SIZE!! Lowermost LCA Nut- Lost Mine
 

Or a nice 3 pound hammer and good positioning, Balljoints are not so hard.

Re: NAME THIS NUT SIZE!! Lowermost LCA Nut- Lost Mine
 

Or, jack it up by the hub, compressing the spring, and put like the large craftsman ratched in between the control arm and the hub, and then lower the jack fast. Makes the spring separate it for u, and saves your ball join boots. pickleforks = death

Re: NAME THIS NUT SIZE!! Lowermost LCA Nut- Lost Mine
 

thread the nut on it about 5 or 6 turns and beat them shits with a hammer

Re: NAME THIS NUT SIZE!! Lowermost LCA Nut- Lost Mine
 

best way to do it, I've torn too many boots with a pickle fork

Re: NAME THIS NUT SIZE!! Lowermost LCA Nut- Lost Mine
 

uh..... im pretty sure it is a 17 mm. not a twelve. at least on my ef it is

Re: NAME THIS NUT SIZE!! Lowermost LCA Nut- Lost Mine
 

I prefer air hammer. ;D

Using a large hammer and hit nice and solid (hard) on the side of the control arm closest to the threads, but not the threads, you can split it pretty easy, if its not working, put your purse down Sally... No really, put a prybar between the spindle and control arm, put force on it so its like you are trying to seperate w/ prybar only, but then hit the control arm as your prying. It will split right apart. If you are reusing the balljoint, make 100% sure you dont booger the threads up, you wont get the nut back on, maybe if you have a good impact gun, but still very bad idea cross threading ----. If youre replacing the BJ, just smack the end :P

Then again, cross threads are better than no threads right :S