i just installed my gsr and it wont start it cranks over but it just wont vroomm it has fuel and spark used a single vtec wiring harness? any help

 

You Got Fuel.. you know this because? I assume you loosened the fuel inlet bolt and tried cranking it over and fuel sprayed right?

You got spark... You put a extra spark plug in a spark plug wire and grounded it out... and when you cranked it over it was sparking right?


Ok, the only 2 other things you need for it to run, is 1 compression and 2 timing. I would check if you have compression in all the cylinders, 2 check your timing, have you had the head off? has the timing belt been off? Is the firing order right? Does the car act like it wants to start? Do you have any check engine lights at all?

Let us know.

 

found out the prob the head is fooked thx for post comp is like 120 160 90 80 and it does sound like it want to start but wont

 

Could it be the battery is just weak, that will give you similar comp #'s? Spescially if you got the 120 and 160 backwards, teh compression will read that way as the battery barfs.....

 

Also check valve lash. Overtightened will lose compression. I've seen it happen a couple times.

 

must be why my motor wont start right away lol

 

FWIW, I don't trust fuel at the rail overmuch. I normally yank the injectors and zip tie them to the rail, then crank to make sure they are all spraying and the injectors aren't stuck closed. New in the box Honduh injectors are usually stuck closed, common problem, tap with a screwdriver or extension while pulsing them and OMG EVERYTHING IS OKAY FOREVER.

*ahem*

Yup, I should not have had that fifth cup of coffee.