b16sellout

Is there an accepted standard minimum number of mounting points for a roll cage/bar to mount harnesses to. I'm not looking for a full on cage, I'd like to keep all the piping in the rear of the car (none running alongside the seats). Just want to be able to mount harnesses to it and not have to worry about it being strong enough in the case of a crash or something.

Reddy

Why you looking for more rice points at HIN?

b16sellout

I'm not happy with the way my seats hold me in place through the curves actually.

MikeJ-2009

You'll need 4 pts. A main hoop with harness bar and two bars going to the back.

psycho_vince

I think the main hoop and the rear legs have to be triangularly braced. If they dont have to be, Id still do it. What kind of tubing you using, wall thickness, DOM or rolled? I think there is regulations on that also, depending on what type of racing you plan to do if any.

b16sellout

Was hoping that is all I would need.

Not really intending to do any racing per se, I'm not much of a track person. I'll drag a few times just to say I can run such and such. I haven't decided on what I'm using yet, probably end up buying a pre fab piece so I don't have to mess with bending and all that stuff. Welder is not usable right now, need 440v 3phase and I definitely don't have that

Turblow

I bought a c pillar bar and mounted my harness onto that, works perfect

b16sellout

Hm, that's a much easier alternative. Have a strut bar back there at the moment too, was kind of weary of using that though.

SkunT

get a better seat. my recaro with factory belts hold me just fine.

b16sellout

I'll probably buy non-adjustables because they're cheaper and I sit straight up anyways, I don't think the factory seat belt will be the best choice to go with the seats I'm considering.