main and rod bearings
 

I havent decided what bearings I would like to use I was up until 3 in the morning today doing research and reading up on bearings and theres a lot of confrontation about what kinds and stuff I was just wondering if I take the specs and put the bearing kit in will it work or will I have to get different sized bearings? im confused Ive never done a bearing replacement

Re: main and rod bearings
 

Just use the stock OEM bearings. I don't really understand your question, it's pretty straight forward. If in doubt grab a manual.

Re: main and rod bearings
 

look at the honda manual. it will show you where to find the stamps on the block, crank, and rods. Then you can use the chart to identify the correct color bearing to get from Honda.
When you get the bearings, use some platiguage to check that the clearances are within factory specs. You may have to go up a size bearing depending on your measurements.
good luck.