What modifacations if any would need to be done to put a type r manifold onto a B16a1. also what would be teh gains of it.

Thanx

 

The manifold will bolt right on, the ITR Intake bolt pattern is the same as a B16a. As far as sensor modifactions, I think everything is pretty much plug and play. You may have to lengthen some wires to get all the connectors fitting properly... And hopefully the throttle cable bracket sits in the same spot..

I have seen dyno graphs show 5-10hp with the itr manas.

Jeff

 

thanx a ton man!!

 

what bout ITR cams in a b16?

 

They also fit, but I think most people recommend using the ITR/CTR valve springs/retainers when doing this. But I have known people that didnt, and it works fine. Its just a bit risky and a higher chance of valve train float.

Jeff

 

Well there are a couple of things you will need. If you are getting a bare manifold. You need a iacv valve from a 94+ b series motor any will work. Same for the fuel rail 94+ b seires. Trust me on this one. i have it on my b16 and the parts from 1st gen b16 will not work. been there done that.