JoshMO

So I finally located a B-000 tranny, I got it off this kid for $80. The only thing wrong with it is I noticed there was some back and forth play in the input shaft. So I tore it apart and noticed it was missing about 4-5 ball bearings around the input shaft on the inner part of the bell housing. I've looked everywhere for a replacement bearing for this. But no one has it that I'm aware of. O'reilly's checked the NTN part# ( NTN SCO5A61) with no luck. I'm at a dead end. This is the first time I've ever been inside a tranny and my manual doesn't cover anything on the inside of the tranny. Someone help me out with this, as I need to be putting this tranny on this week or I'll be walking. Bone I know you know this stuff, chime in man. PLEASE

Thanks


Another question would be.

Am I suppose to just repack this race with new bearings? Or is there a complete bearing pack that goes around the input shaft. I noticed when I pulled the gear set off that there was just the race and the bearing surround the input shaft. No inner "small metal circle" like a typical bearing would have. I am very confused about what to do from here.

JoshMO

Well I searched and found the part numbers on this site. I'll hit up a dealership tomorrow. Hopefully I'll get lucky.

txdohczc

some where there is a write up on how to change the isb. it gets in to all the details it may be on d-series or ht(gayest site ever)

txdohczc

i dont know if you already looked it up or not but here is the write up i was talking about http://www.d-series.org/forums/showt...hlight=bearing

Bone1

Got B000 ISB bearing and 4 seals sitting here.

MAJORAHOLE

i did it in my tranny, i forget where the write up was though. it was a little intimidating.
i'm sure bone knows where that write up is

JoshMO

Bone, if I can't find one local how much you want for one and a seal? PM me and let me know.

JoshMO

Well I was unable to find one local. Bone hit me up. You've got PM man.