Installing Rear main seal
installed the rear main seal last night...
but it kinda feel like it`s not being driven deep enough when i turn the flywheel(u can hear a very little scrubing sound)...but teh outer lip of the seal is already on the origional place is it suppose to make those noise or did i ---- up? |
Re:Installing Rear main seal
did you lube it up at all?
|
Re:Installing Rear main seal
Did you compare it to the old one and see if they were similiar. I think it should be flush and not touching the flywheel at all.
|
Re:Installing Rear main seal
i did lube it up and i did it guuood ;)
and the manual said put it back to where`s it was and leave the same clearence in between the seal housing and the seal..which is what i did... not sure if it is touching or not but it sounded kinda like it. i mean it`s just a little bit of noise..kinda like ur touching the flywheel with a piece of paper while spinning it. or is it just how it suppose to sound?? ??? |
Re:Installing Rear main seal
what kind of car engine is this.
|
Re:Installing Rear main seal
it`s a Z6...
ok i found out it`s not from the clutch..but form the crank. problem sloved ;D |
Re:Installing Rear main seal
:) :) :) :) Tight.
|
All times are GMT -5. The time now is 11:57 AM. |
© 2024 MH Sub I, LLC dba Internet Brands