I have a lip in my cylinders, question about doing a hone.
#1
I have a lip in my cylinders, question about doing a hone.
I have a d16z6, i'm going to get the motor cylinders honed tomorrow. This is my first engine build and I feel an edge where the old pistons landed at the top of the cylinders. Since i'm going lower compression i figured i could just have it honed to remove the glaze and the lip wouldnt matter since the new pistons will not reach that high in the cylinder.
Am I right or wrong? opinions?
Nick
Am I right or wrong? opinions?
Nick
#5
Re: I have a lip in my cylinders, question about doing a hone.
Originally Posted by Sinner
I have a d16z6, i'm going to get the motor cylinders honed tomorrow. This is my first engine build and I feel an edge where the old pistons landed at the top of the cylinders. Since i'm going lower compression i figured i could just have it honed to remove the glaze and the lip wouldnt matter since the new pistons will not reach that high in the cylinder.
Am I right or wrong? opinions?
Nick
Am I right or wrong? opinions?
Nick
Thread
Thread Starter
Forum
Replies
Last Post
Walter
General Discussion
16
02-24-2008 11:47 PM