I ------- HATE AXLES!!!!
#1
I ------- HATE AXLES!!!!
Well, ripping out the b16 proves to be more difficult than it should be. ONLY BECAUSE THE AXLES WONT BUDGE!!!!! I'm going to take a crowbar to them tommorrow, those bastards will pay.
Just venting...
incase you want to know they wont come out of the tranny
Just venting...
incase you want to know they wont come out of the tranny
#3
Re:I ------- HATE AXLES!!!!
I just changed my clutch yes they are bastards just stick a screw driver to get a little seperation then stick the crow bar in there and pop those bitches out. and your going to have to hammer them in.
peace
peace
#6
Re:I ------- HATE AXLES!!!!
Well I got the passenger axle out but not the drivers side. I don;t know what it is it just wont come out. I got the engine out by picking the car up, but I still need to get the axle out somehow.
#7
Re:I ------- HATE AXLES!!!!
dude, good luck! i had the same problem before, it ended up being that my intermediate shaft was shot, so the heat that i was causing, cause the splines on the end of the axle to expand and get stuck in the intermediate shaft. i ended up having to get a new intermediate shaft and axle.......
#8
Re:I ------- HATE AXLES!!!!
You might have to beat the living ---- of it if the clip that holds the axle in is broken. Keep beating on it, it'll come out.
When I took my d16 out, the stupid axles were stuck in the hubs, I beat one out with a big hammer, the other we couldn't get out and managed to ruin the wheel bearing in the process, then we needed to take the whole spindle off and get it pressed out. When it finally let go in the press it sounded like someone fired a .357.
Good luck, you'll get it eventually!
Stan
When I took my d16 out, the stupid axles were stuck in the hubs, I beat one out with a big hammer, the other we couldn't get out and managed to ruin the wheel bearing in the process, then we needed to take the whole spindle off and get it pressed out. When it finally let go in the press it sounded like someone fired a .357.
Good luck, you'll get it eventually!
Stan
Thread
Thread Starter
Forum
Replies
Last Post