engine + cable tranny? just trying to get an idea, thinking of just throwing one in the back of a car (not the CRX) and me and my roommate being able to take it out? we lifted my ZC easily the B16 weighs a little more right?

 

It weighs pretty heavy dude. Just the engine alone is pretty heavy. I was pretty amazed the first time we lifted just the engine out of the back of beaus car.. I highly recommend a small truck or something with a bed. I dont know the aprox it weighs. But unless you take it apart from the trans its going to be to heavy to move around into a car.

Jeff

 

so if we seperate the tranny it will be managible?
btw i didnt get the truck the engine that was going in it was bad.

 

it took 4 people to lift my first b16 and tranny on the pallet into the back of a toyota pickup it was no fun. Id would just have it delivered to the place that your doing the swap or you could seperate them that would be easy.

Beau

 

I think it would be too much to handle, even taken apart. The trouble is trying to lift it out and over the ledge, very bulky. You guys should be able to lift an engine alone off the back of a pickup and set it onto the floor though, but thats about it.

I was able to get a B18c short block off the back of my pickup and onto my engine stand by myself once.

 

damn i need that truck. anyone have or know someone that has a good 20R engine?

 

dustin theres about 100 of those engines at pull a part just go crab one and slap some new bearings in it.

Beau

 

thats where the last engine came from and it was a ---- motor. i have someone on the inside on the look out for a truck/motor...

 

I had the same problem with my old toy 20R. The truck had like 280,000 miles on it and drove fine, but the engine would barely idle although it ran great at speed. I sold it in Bellingham because it couldn't pass the smog test.

 

and to anser is niko niko.....
It is around 475lbs