how do u use the clutch alignment tool?
#1
how do u use the clutch alignment tool?
the key suppose to stick into the pilot bearing right?..
the problem i have is that the key will not go into the hole, it`s like too big....
Dam....was going to assem. everything tonight... and everywhere will be closed tomol ....
the problem i have is that the key will not go into the hole, it`s like too big....
Dam....was going to assem. everything tonight... and everywhere will be closed tomol ....
#2
Re:how do u use the clutch alignment tool?
Yeah, the tool is supposed to fit into the center of the pilot bearing. Then you just slip the disc over that and bolt up the P.P. Maybe you can shave some off the end of the tool until it fits, just make sure the clutch disc will still be centered.
#4
Re:how do u use the clutch alignment tool?
Do you have the universal clutch alignment tool where you can usually change the end piece to fit into the pilot hole? Or you using the one that came with the clutch which is a plastic clutch alignment tool?
#5
Re:how do u use the clutch alignment tool?
i used my old PP and bought the disc seperate...
got thata tool seperate also...they are from ACT
it`s like 2 mm bigger all around
BTW my tanny `s out already...houdl i do it while standing up the tanny ? :P
got thata tool seperate also...they are from ACT
it`s like 2 mm bigger all around
BTW my tanny `s out already...houdl i do it while standing up the tanny ? :P
#6
Re:how do u use the clutch alignment tool?
You can't install it in the tranny first because the pressure plate has to be bolted to the flywheel. you need to find a way to use that tool or go buy another one. It can be done without the tool but if you don't get that clutch disc straight, the damn pilot shaft of the tranny is going to be a bitch to get ligned up.
#7
Re:how do u use the clutch alignment tool?
Originally Posted by tranceminister
You can't install it in the tranny first because the pressure plate has to be bolted to the flywheel.
geees. have to wait till next monday t get goin i guess :P
#8
Re:how do u use the clutch alignment tool?
You should make sure the the pilot bearing that you have is the right one. Slip it over the end of the input shaft of the transmission, it should fit just perfect. If it's too big, you'll end up with other problems, esspesially if you are pushing more power than stock. If the bearing doesn't support the shaft correctly, you will end up with a transhed tranny.
#10
Re:how do u use the clutch alignment tool?
I have installed clutches without an alignment tool. Sometimes you get lucky and it goes right in, sometimes it's a mother ------- ---- *** bitch and you throw ---- all over the garage because you're so pissed off because you can't get the damn thing to line up.
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote